Yealink SIP-T21 Manuel d'utilisateur télécharger pdf (Page 26)

User Guide for the SIP-T21P/SIP-T21 IP Phone

will perform a PPP negotiation to obtain the IP address. Contact your system

administrator for the PPPoE user name and password.

To configure PPPoE via phone user interface:

1. Press Menu->Settings->Advanced Settings (password: admin) ->Network->WAN

Port.

2. Press to select IPv4 and press the Enter soft key.

3. Press to select PPPoE IP Client and press the Enter soft key.

4. Enter the user name and password in the corresponding fields.

5. Press the Save soft key to accept the change or the Back soft key to cancel.

Note

Generally, your phone will be deployed with multiple other phones. In this case, your

system administrator will configure the phone parameters beforehand, so that after you

start up your phone, the phone will be registered and ready for use. If your phone is not

registered, you may have to register it. For more information on how to register your

phone, refer to Account Management on page 54.

If the phone has successfully started up, the idle screen will be shown as below:

The idle screen shows the label of current account, time and date, and four soft keys.

Wrong network settings may result in inaccessibility of your phone and may also have an

impact on your network performance. For more information on these parameters,

contact your system administrator.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 141 142

Pas de commentaire

Yealink SIP-T21 Manuel d'utilisateur Page 26